Memorial day is one of the biggest outdoor cooking days of the year and while you have lots of options, I am going to show you how to make my onion and cola smoked spare ribs as well as smoked brats and smoked boudin.
I hope all of you have a wonderful time with family and friends as you think upon and honor those no longer with us.
Look no further than the smoking meat newsletter archive to find plenty of smoking meat recipes as well as methods and help on how to smoke meat in your smoker or grill.
- Prep Time: 30 minutes
- Cook Time: 5-7 hours
- Smoker Temp: 250°F
- Meat Finish Temp: Done when tender
- Recommended Wood: Mesquite and cherry Mix
- 1 or more racks of full spare ribs or St. Louis spares
- Apple cider vinegar
- 2-liter bottle of cheap cola
- 4 medium yellow onions
- 16-20 cloves of garlic
- Jeff's rub recipe (purchase the recipe here)
- Jeff's sauce recipe (purchase the recipe here)
- Thermapen (for checking the rib meat between the bones for perfect doneness)
Rinse the ribs under cold water and lay meaty side up on a cutting board
Remove any extra clumps or layers of fat then flip the rack of ribs over to bone side up.
Remove the flap of meat that runs along the bottom of the ribs if has not already been trimmed off by the butcher. This helps it to cook more evenly.
Remove the membrane (thick plastic stuff) by prying up with your fingers or a sharp object such as a butter knife. Once you are able to get ahold of it, use a paper towel or some catfish skinning pliers to get a good grip and pull it clean off. If it tears, just get another good hold on it and finish the job.
Removing this membrane is important as it allows the smoke to get to the meat better and makes for more enjoyable eating later.
I usually apply a thin coat of yellow mustard to the ribs but decided this time to use apple cider vinegar to wet the surface instead. I am not sure this little bit of vinegar will tenderize the ribs like some say, but figured it would not hurt.
Let the ribs sit for about 5 minutes to allow the rub to mix with the apple cider vinegar and get that familiar “wet” look.
Note: you can flip the ribs over and season the other side now or you can wait and season them after placing the ribs on top of the onions and garlic in the next step. Doesn't matter when.. as long as you do it.
Slice 2 onions into ¼ inch slices and separate the rings into the pan.
Place 8-10 garlic cloves all over the pan in with the onion rings.
Pour cola (I used the cheap stuff) to about ½ the depth of the pan.
Now it is time to cut the rack of ribs in half and lay one of the halves bone side down on top of the onions.
If you decide to use St. Louis cut or even baby back ribs instead, you'll probably be able to fit more than just a half rack into each pan.
Pour some apple cider vinegar onto the rib half and use a brush or your hands to spread it all over the ribs making sure the entire surface is wet.
Note: you can definitely use yellow mustard if you'd rather. It works great and while I like to experiment, there's something to be said for, “if it's not broke, don't fix it”.
Let it sit for a few minutes while the rub and vinegar combine to form a paste. (this is a great time to go get the smoker ready).
Note: For brevity, I did not show the 2nd pan.
Prepare a 2nd pan in the same way as the first using the other half of the rack of ribs, 2 more onions, 8-10 more garlic cloves and more cola.
Normally we smoke at about 225°F and if you can't get any hotter than this, that is fine. If you CAN go hotter, I recommend shooting for about 250°F to cause the cola, onions and garlic to steam into the ribs. This will obviously cut down on the amount of time you would normally cook the ribs.
Get your smoker lit or plugged in and setup to maintain 250°F or as close to that as you can muster.
I recommend having enough smoking wood to last at least 4 hours if possible.
Once your smoker is preheated and maintaining the coal temperature, you are ready to move forward.
Place the pan of ribs on the smoker grate.
If your smoker has a water pan, use it and keep it full throughout to promote a nice humid environment in the smoker.
Continue adding smoke for at least 4 hours or until the ribs are completely done cooking.
Note: After a few hours the onions and garlic will cook down and create a lot of liquid in the pan, you may want to remove the ribs from the pan at that point and just lay them directly on the smoker grate. If you want to wrap the ribs in foil for a couple of hours, you can certainly do that as well after about 2.5 to 3 hours.
For ribs, we do not use temperature to determine when they are done however, I did check the ribs with my trusty Thermapen when they were super tender and I was reading about 195°F .. perfect temperature for pork ribs in my opinion.
I recommend bending the ribs, pulling the bones apart and even going so far as to taste one of the ribs to allow you to make a determination of “done”. They are done when they are as tender as YOU and YOUR family likes them.
There are NO RULES about the tenderness of pork ribs unless you are competing in a barbecue contest. If you like them overdone (falling off the bone) then that's the way you should do them.
Make them just as tender as you like, you and your family are the judge at your own house 😉
I highly recommend using a Thermapen to check the temperature of the ribs, In my opinion, they are pretty darn near perfect at 195°F. Checking the temperature of pork ribs is difficult to do unless you have a thermometer like the Thermapen that has a very small diameter probe that will fit between the bones and give you an accurate measurement.
When they are done, you can wrap them in foil, then in a towel and hold them for several hours in a cooler if you need to or you can go ahead and slice them up and divvy them out.
If you want to use baby ribs you can but they will get done about an hour sooner usually. Check for tenderness and/or use a Thermapen to check between the bones for 195°F. I recommend the non-meaty baby backs as that extra meat on the ones marketed as ” extra meaty” is just loin meat which is leaner and tends to dry out when cooked beyond 145°F.
If you don't like onions, try using cobs of corn or even potatoes instead to hold the ribs up off the bottom of the pan. The corn/potatoes will benefit from the cola and the rib juices as well.
You can also substitute an equal amount of sliced sweet peppers for one of the onions.
If you want the ribs to be more tender, consider removing the ribs from the pan after about 2.5 hours and wrapping them in foil for 1.5 to 2 hours. Afterwards, remove the foil and lay them on the smoker grate for 45-60 minutes unwrapped to firm up a little. This is also a great time to add some of my original barbecue sauce (purchase the recipe here) if you like sticky ribs.
Want to try something besides cola? Go for it.
How to Smoke Brats and Boudin
Brats and even links of boudin are very easy to smoke, but you can easily overcook them and make them tough or dry them out. Follow these simple instructions, and they will turn out perfect every time.
I like to place the brats and/or boudin on a Bradley rack. You can also just lay them directly on the smoker grate rounded side up (that was a joke).
Pictured at left are german style brats, the two links at top right are boudin and the ones at bottom right are American style brats.
Preheat the smoker to 225°F
Make sure you have enough smoking wood for 2 hours.
Smoke the brats for exactly 2 hours and they are done.
The boudin is done when the skin is bite through crispy but the inside is not dried out. This is usually about 2 hours but I have went as long as 2.5 hours before.
Throw on an extra link and try it at 2 hours. If it's not done, go a little longer.
Note: this is one of the great reasons for smoking boudin instead of steaming them, microwaving them or any of the other ways that folks heat them up. The skin, when smoke cooked, is completely edible, has a slight crispiness to it and there is no need to peel off the skin.
Serve and Enjoy!
***Note: you get the Texas style rub recipe free with your order!
If I could give these recipes away, I would do that. I really want you to have them! But, then, this is how I support the newsletter, the website and all of the other stuff that we do here to promote the art of smoking meat.
Read these recent testimonies:
I recently purchased both recipes. The files did not come thru right but Jeff was prompt to get it fixed. I tried them both last weekend and they were a huge hit. I followed his burnt ends recipe to the letter and my neighbors thought I was some master chef! Thanks Jeff! -Susan T.
Thank you for the great advice. Followed your rib recipe and everyone loved them. Used your rub and sauce. On point! -Charles W.
Love the sauce and rub recipes. So far I have used them on beef ribs, pork ribs, and different chicken parts. Can't wait to do a beef brisket. Texas rub is great as well! -Peter S.
Love the original rib rub and sauce! We have an annual rib fest competition at the lake every 4th of July. I will say we have won a great percent of the time over the past 15 years so we are not novices by any means. However, we didn't win last year and had to step up our game! We used Jeff's rub and sauce (sauce on the side) and it was a landslide win for us this year! Thanks Jeff for the great recipes. I'm looking forward to trying the Texas style rub in the near future! -Michelle M.
I tried the rub on a beef brisket and some beef ribs the other day and our entire family enjoyed it tremendously. I also made a batch of the barbeque sauce that we used on the brisket as well as some chicken. We all agreed it was the best sauce we have had in a while. -Darwyn B.
You see the raving testimonies and you wonder, “Can the recipes really be that good?”
No worries! Make up a batch and if it's not as good as you've heard.. simply ask for a refund. Now that's a bargain and you know it. Let's review:
- You decide you don't like the recipes.. you don't pay!
- The recipes are absolutely amazing!
- Once you order, there'll be no more recipe ads in the email version of the newsletter
Well.. what are you waiting for.. click on the big orange button below to order the recipes now.
With more than 900 reviews on Amazon.com and a rating of 4.7 out of 5 stars, it comes highly recommended.
It is a Bestseller in Barbecueing & Grilling books on Amazon.
If you enjoy the newsletter and would like to do something helpful, then..
The next time you decide to order something at Amazon.com, use THIS LINK to get there and we'll get a small commission off of what you purchase.
Thank you in advance for using our special link: http://www.smoking-meat.com/amazon
- 1 rack of spare ribs
- Apple cider vinegar
- 2- liter bottle of cheap cola
- 3-4 medium yellow onions
- 16-18 cloves of garlic
- Jeff’s rub recipe
- Jeff’s sauce recipe
Rinse ribs under cool water
Remove any large areas of fat on meaty side of ribs
Flip the ribs over and remove the membrane from the bone side
Wet the ribs with apple cider vinegar
Apply a generous coat of Jeff's rub to the bone side
Turn the ribs over and apply the vinegar and rub to the meaty side
Cut the rack of ribs in half
Slice two onions into ¼ inch slices and separate the rings
Place the rings and 8-10 garlic cloves in a large foil pan
Pour enough cola to fill the pan to about ½ full
Lay one of the rib halves on top of the onions and garlic
Prepare a 2nd pan in the same manner for the other half of the ribs
Set up smoker to cook at about 250°F
Place the pan(s) of ribs onto the smoker grates
Cook for 5-6 hours or until they ribs are as tender as you like them