| |

Smoked Beef Country Style Ribs

IMG 8224

Smoking-Meat.com is supported by its readers. We may earn an affiliate commission at no extra cost to you if you buy through a link on this page.

Read this article without ads

These beef country style ribs are not only extremely flavorful and easy to cook but they are fairly inexpensive as well and in my book, that's always a plus.

Much like their pork counterparts, they are cut from another larger piece of meat and repackaged. Usually the beef variety are cut from the chuck roast which has just enough fat marbling to make it do very well in the smoker. Why am I telling you this? Well, if you can't find the beef country style ribs in your local supermarket or wherever you purchase meat, simply purchase a chuck roast and cut it lengthwise into pieces about 1.5 inches thick and you will have successfully made your own.

The cool thing about cooking these instead of the whole chuck roast is that it gets done a lot faster, it's already cut up into portions that are ready to serve, each piece has it's own smoke ring all the way around, and it allows you to get the rub and/or sauce onto all sides of the portions instead of just the top and the bottom.

Purchasing the Ribs

These usually come in a package with 4-5 pieces. They are typically boneless and are cut from the chuck roast in most cases. If you can't find them, you can purchase a chuck roast and cut it into 1.5 – 2 inch strips lengthwise or ask your butcher to cut it for you.

Pieces of Beef Country Style Ribs

Preparing these Ribs for Smoking

These hunks of meat require very little preparation. Treat them sort of like brisket and just coat them real good with my rub recipe either the night before or right before you cook them. To help my rub to stick, I usually use yellow mustard but today I experimented with just using some butter flavored spray oil and it worked wonderful.

After spraying the ribs real good with the spray oil, coat them on all sides with my rub making sure to use it generously. Once all the ribs are coated, leave them laying while you go and get the smoker going.

Coated with rub

Getting Ready to Smoke

This process will vary somewhat depending on what type of smoker you are using. Be sure to use the water pan if you have one available for your smoker and feel free to substitute some of the water for some other liquid such as beer, juice or even broth. I do not have any proof that it adds to the flavor, but it certainly seems to and it's something that I think everyone should try and see if you like it.

Build your fire, light the burner or plug it in and turn it on.. do what is required to preheat your smoker to 225 degrees. Once the smoker is ready, the ribs can go on.

Beef country style ribs on smoker grate

Smoking the Beef Country Style Ribs

Place the beef ribs directly on the grate making sure to leave about 1 inch between the pieces if possible to allow the smoke ample room to flow properly.

I recommend holding the smoker to 225 or even slightly lower as much as possible to keep the rub from burning and to give you the best possible end result.

As has been the case for the last several months, I had to use my gas smoker due to the burn ban that we are under in the majority of Oklahoma counties. The grass and trees around here are very dry and the smallest spark can start a grass fire that just won't quit. I have to be very careful even with the gas smoker.

The gas smoker does a very nice job in my opinion and makes it really easy to maintain a set temperature.

I smoked the ribs with a combination of dry hickory chunks and dry hickory chips and kept the smoke going for about 4 hours.

Dry hickory chunks and chips

The ribs took right at 5 hours to reach 180 degrees internal temperature.

Nice smoke ring on beef country style ribs sliced thin

Brush a thin layer of my barbecue sauce recipe onto the ribs about 30 minutes before they are finished cooking if you like.. it gives them an extra layer of flavor and it makes them shine.

Notes:

  • To get the ribs even more juicy and tender, you can wrap them in foil once they reach about 140-160 degrees. One caveat of this method is that it will soften the bark on the outside.
  • It was very gusty while I was cooking these which tends to lengthen the cooking times somewhat. You may find that you can get them done more quickly than I did on a typical day.
  • Use a robust wood like mesquite, hickory, pecan or oak for the most pronounced smoke flavor.

Frequently Asked Questions

Q: When I am smoking meat, it almost always gets done faster than the times that you recommend.. why is this?

A: Smoking is an indirect method of cooking and ,in general, 225 degrees in one smoker should be 225 degrees in another smoker with no regard to the heat source. This same measure of heat should get somewhat equal pieces of meat done in about the same amount of time. Unless of course, it's not completely indirect.

To better explain this, I have noticed that the meat just above my water pan in my gas smoker get done a lot slower than the meat that is closer to the edge/sides of the smoker. This is because the water pan is the baffle for the heat. The heat comes up along the sides and even though it still measures the same, the radiating effect of that heat on the sides vs the completely indirect heat above the water pan will cook the meat quite a bit faster.

I have learned to keep most of the meat away from the sides to help it cook evenly.

If your smoker at 225 cooks meat faster than my smoker at 225 then something is different and the only thing I can think of is that there is some radiating heat coming from somewhere that is doing a more efficient job of cooking the meat. This assumes that you have checked and proven that your thermometer is accurate.

Q: How long should I keep the smoke going when smoking various types of meat.. you don't always say how long?

A: Most importantly, I will try to start giving a recommendation for how long to apply smoke for those of you with charcoal, electric and gas smokers.

I also have a method for calculating my minimum requirements for smoke application:

1/2 x Total Estimated Cook Time

  • Chicken = 4 hours Cook Time/2 hours minimum smoke application
  • Spare Ribs = 6 hours cook time/3 hours minimum smoke application
  • 10 lb Brisket = 15 hours cook time/7.5 hours minimum smoke application

Please note that it is perfectly ok to apply smoke for the entire time the meat is cooking. After all, in a wood fired smoker, the heat and smoke are inseparable without wrapping the meat in foil and in many cases, this is why meat from all wood smoker are considered to be some of the best and most flavorful you can eat.

Get Jeff’s Products!

Leave a Reply to Reith Cancel reply

Your email address will not be published. Required fields are marked *

One Comment

  1. So do I should turn the country style ribs beef over like two hour then turn over the meat or should just leave it alone?