Hello friends and welcome to the May 2010 edition of the smoking meat newsletter. With Memorial Day just around the corner, many of you are starting to think about what you will cook and hopefully I can give you a helping hand with that.
As usual on holiday editions, I am going to provide some resources for smoking things like ribs, brisket, and pork shoulder but I am also going to cover something in this newsletter that I have never talked about in the newsletter before..
Smoking cheese!
I have been asked time and time again how to produce smoke without any heat and over the years I have given suggestions like using a couple pieces of charcoal with some wood chips or the soldering iron in a can full of wood chips, or the double smoker method where you use one smoker to produce smoke and attach it to another smoker full of cheese with a dryer hose.
These are all options that work but I would not say it works well and it certainly is not as simple as I think it should be.
Over the last few months I have received two different smoke generators to try out and I am duly impressed with both of them so I have decided to show you these products in this newsletter.
I will tell you a little about the products, show you how to set them up and use them and give you some general information on smoking cheese.
Are you ready to get started? I know I am!
Todd Johnson over at AmazenProducts LLC contacted me a while back and asked if I would review his A-Maze-N-Smoker and Of course, I was only too happy to do that.
I received the package promptly a few days later and here are my perceptions from that experience.
Packaging: It was wrapped well and was not bent, warped or otherwise damaged in any way. after looking at the product and how well made it is, I feel it would survive quite an ordeal with no problems.
What was in the Box: (1) 6"x6" smoker, (1) bag of hickory dust, (1) set of instructions
Initial Impressions: I was amazed at the simplicity of the product and I have to admit that at first, I was a bit skeptical considering it did not plug in and it did not look like a high-tech gadget in any way.
It was solid, built of 304 stainless steel and the construction was very good making me believe that it would easily last for quite a few years.
Setup: minimal setup is required. Pour about (2) cups of dust into the unit making sure the dust is not above the walls of the maze.
Operation: Light one or both ends with a butane torch or other lighter for 15-30 seconds and place in smoker for up to six hours of thin blue smoke.
Results: I was truly amazed at how simple it was to light and operate. I can see this being used even in hot smoking to keep from having to continually add wood chips or chunks to an electric, gas or even a charcoal smoker.
Smoking Time: Produced light smoke for 6 hours and 40 minutes unattended
Pros:
Cons:
How to order: http://www.amazenproducts.com
The A-Maze-N-Smoker Empty
Special smoking dust
About 2 cups of smoking dust will fit in the smoker
Make sure dust is not over the maze walls and slopes downward at the ends

Light with a torch or Lighter at one end
Place in smoker on bottom rack - close to air vents
Here it is at 2 hours of smoking..
Here it is at 4 hours of smoking..
And here it is finally at 6 hours and 40 minutes of smoking..
Dennis Correa from Smoke Daddy Inc. asked me to look at his "Big Kahuna" Smoke Daddy smoke generator and he was so generous in sending me not only the smoke daddy, but several bags of what he calls the "perfect mix" which smelled wonderful.
Packaging: The Smoke Daddy was packaged extremely well and was well wrapped with multiple layer of newspaper. There was no damage to the product and everything was intact with the exception of the thumb screw which had fallen out but was easily found inside of the paper the cylinder was wrapped in. Perhaps a piece of tape would alleviate this in the future.
What was in the Box: (1) Big Kahuna Smoke Daddy, (1)top cover, (1) bottom cover, (1) bag of wood chips, (5) wood chunks, (2) bags of wood pellets, (1) fish tank pump
Initial Impressions: I was impressed with the quality of the parts. Precision made aluminum cylinder with top and bottom cover that fit perfectly. Pellets were high quality with a good wood smell. Overall a very solid unit that gives the impression that it will last a lifetime and then some.
Setup: For me, I was fortunate enough to have a 7/8" hole in my grill and opted to use this instead of drilling out a 3/4" hole in one of my smokers and therefore setup was very minimal. For most folks, there will be a few minutes of time involved with marking and drilling a 3/4" hole your smoker or grill for installing the smoke daddy.
I installed the smoke daddy with no tools, the nut only needed to be finger tight to hold it securely to my grill.
Operation: Lit a small piece of charcoal on the side burner of my grill and placed it in the bottom of the cylinder. I then poured about 3 cups of wood pellets into the cylinder, installed the top and bottom covers, plugged in the fish tank pump and let her smoke.
Results: The smoke daddy produced beautiful smoke that was medium to heavy in volume and looks like it would easily generate enough smoke for a fairly large smoker.
Could even be used to produce smoke during hot smoking especially for products that require long hours of low heat. The smoke daddy could easily have been refilled with a small piece of charcoal and more pellets in less than 5 minutes if I had opted to do that.
Smoking Time: Produced medium to heavy smoke for about 3 hours unattended
Pros:
Cons:
How to Order: http://www.smokedaddyinc.com
What's included in the box?
E-clip can be adjusted for a thick wall application
Air inlet creates a draw from the bottom of the smoker and pushes smoke out of the pipe
Air flow is provided via a fish tank pump
Air flow is adjustable via a small plastic valve
Bottom cover with wooden handle and vent holes
Thumb screw for holding bottom cover in place
Top cover with wooden handle

Drill 3/4" hole in desired location - I found a 7/8" hole in my grill and used that instead
Install Smoke Daddy with a washer and nut
Light small piece of charcoal - I used the side burner on my grill and it worked great
Once charcoal is lit, place in bottom of cylinder and fill cylinder with smoking pellets
Place top cover on cylinder and attach fish tank pump
Watch the smoke start coming out of the Smoke Daddy
In general smoking cheese is quite simple especially if you are able to use one of the products I have reviewed above. The temperature needs to be no more than 90*F to prevent melting.
The cheese should be cut into pieces that are no more than 1" thick and 3-4" wide at any point. This allows for more smoke penetration.
Place the cheese on the top grate with about 1" of space between them to allow for better smoke application.

Let the cheese smoke for 2-6 hours depending on how heavy the smoke is, what type of wood you are using and how much smoke flavor you want in the cheese.

This is the hard part..
Once the cheese is finished smoking, wrap in saran wrap, vacuum pack or place in a ziploc bag for 2 days to 2 weeks to allow the smoke to disperse all the way through the cheese.

In my opinion, the longer you wait the better the cheese tastes. I like to wait about 8 days before tasting the cheese.
Some of my favorite smoked cheeses are Sharp Cheddar, Parmesan, Mozzarella, Gouda, Muenster, and Edam
Folks.. I never stop amazing myself at how good my rib rub and barbecue sauce is on various kinds of meat.
Whether it is ribs, brisket, pork shoulder or even something simple like chicken or chops, every time I use my rub and sauce I am blown away by the flavor all over AGAIN!
I always think to myself, "I sure hope everyone can try this.. it is too good to go through life never having experienced this!"
I am not being dramatic.. just try it and you will join the ranks of those who know if I'm lying then I'm dying! This stuff is Fan-flavor-tastic and you need it in a bad-bad way;-)
Here is a few testimonies from other folks who took the plunge and are proud of it. Be sure to send my your testimony once you try it and realize that you have just tasted of HEAVEN.
---------------------------------------------------
Jeff,have tried the Rib Rub and Sauce recipes several times.Simply awesome. Nothing more needs to be said
---------------------------------------------------
I have purchased and used your Rib Rub and love it! I recommend your website to anyone who inquires how I transform a raw piece of meat into the slice of heaven currently in their mouth
---------------------------------------------------
I am making a lot of the rub for my kids in Tampa, Las Vegas and Denver. It is the best. They have the sauce and rave about the results.
---------------------------------------------------
Jeff, I have tried allot of "bottled" sauces and a few home made ones to......This stuff is GOLD! It was a big hit Labor day..
---------------------------------------------------
You deserve the very best and is is completely within your grasp! Only $18.95 and worth every penny. Not only do you get the best rub and sauce recipe available, you are supporting this website and helping to make sure the bills get paid so we can keep on doing what we do to teach thousands and thousands of people across the world the art of smoking meat.
Order Recipes
NOTE: My system is automated which means you should get a download email within MINUTES of ordering..check your spam/junk folder first then contact me to get the recipes sent to you as an attachment.
Here are some past newsletter articles and links for helping you smoke up everything perfectly on Memorial day. Enjoy and if you need further help, check us out over at smokingmeatforums.com where your questions are usually answered within minutes.
How to Smoke Bacon Wrapped Stuffed Sausage Fatties
Complete Smoking Meat Newsletter Archive
Smoking Meat Forums (SMF) is proud and excited to announce a partnership of sorts with Huddler who has created a one of a kind platform for discussion boards such as ours.
We have been working in the sandbox model for the last several days and the launch of the new platform is slated for this coming Monday. We will be offline starting at about 6 AM PDT and plan to be back up sometime that afternoon or evening depending on how well it goes.
With more than 22,000 members we are the number one smoking meat forum online and this is just another way that we have decided to step up to the plate and show that we are all about being the best for our members.
We will have a fully integrated wiki system, review system, and discussion board with full image album capability and drag and drop organization to allow the members to show off what they smoke.
This has been a long time coming and I hope you join us on the forum to see what all the fuss is about.
http://www.smokingmeatforums.com
We hit 5000 members on our Facebook fan page this past month and it's all because you guys like to stay abreast of great smoking meat information. It's just another resource for asking questions, getting good answers and continuing to learn more about this great art.
Go to http://www.facebook.com/smokingmeat and hit the "Like" button at the top to be a part of this exciting trend.
Thank you for being a part of the smoking meat family which includes the newsletter, the forum, the smoking-meat.com website and many other resources that we try to provide to help you and countless others learn this great art.
A HUGE thank you to all of you who support the site with your donations and by purchasing the recipes and other products that we sell.
Until next time.. keep smoking and God Bless.
Jeff Phillips
The FREE smoking meat newsletter will be coming out
Click here to subscribe.
Latest Newsletter
My famous Rib Rub and Barbecue sauce recipes are just the ticket when you are needing to impress the very best!
Guaranteed to be the best you have ever eaten or I will gladly refund your money.
Order both recipes today for only $18.95 and you will thank me tomorrow!
![]()