Rick Shaw, a newsletter subscriber, smoker enthusiast and one who is obviously not afraid to do things differently, emailed me several years ago mentioning that he slices ribs individually before smoking them. He included his own technique and method for doing this.
I know that people sometimes cut racks of ribs into halves or maybe into pieces that are 3 to 4 bones each but you just don't hear about folks cooking single bone pork ribs. Here's to a new and possibly better way to cook ribs!
- Preparation time: 25 minutes
- Cook time: 5-6 hours
- Smoker temperature: 240°F
- Meat Finish temperature: N/A
- Recommended wood: Pecan and/or Cherry
Remove ribs from package and rinse well under cold water.
Pat dry with paper towels and lay on cutting board.
If the ribs have a membrane (thick plastic-like skin on bone side), it's a good idea to remove it if you can.
Loosen with your fingers, butter knife, spoon, etc.
Grab with a paper towel (for better grip) or you can use catfish skinning pliers as well and pull clean off.
If you are having trouble with it, you can also score the skin with a sharp knife and leave it at that. Don't let it frustrate you.
This is where the normal methods of smoking ribs goes off the rails.
Usually, at this point, we'd add rub and be done with it.
Using this method, I highly recommend waiting until later to add the rub.
Use a very sharp knife and slice right between the bones.
For best results, trim these up St. Louis style. This just means you remove the brisket bone that runs along the leading edge and square them up a little by removing the extra pieces of meat on the ends.
I also recommend that you remove that extra flap of meat on the boney side of the ribs. If there's no flap, it may have already been removed.
Once they are all trimmed up, place them with the bone side facing up and using a sharp knife, slice between the bones.
The extra pieces that were trimmed off earlier can also be cut into smaller pieces if you so desire.
I like to arrange these onto a Bradley rack or a Weber grill pan so I can ensure that all of the pieces get full access to the smoke but it's not absolutely necessary. It is perfectly ok to just put the ribs and pieces into a large foil pan.
Note: If you do not have Bradley racks or these racks do not fit in your smoker, you can also place the ribs directly on the smoker grate with a little space between each one.
These will do well on any smoker or even a grill as long as you can maintain temperatures between 225-240°F using indirect heat.
Make sure you have enough smoking wood for about 3-4 hours of smoke. I used pecan with cherry, use the smoking wood that you like and what you have available to you.
If your smoker has a water pan, I recommend using it.
Once the smoker is set up and holding the proper temperature, you can proceed with cooking the ribs.
The first step in cooking these pre-sliced ribs is to smoke them for about 2 hours at 225-240°F. With no rub and no membrane, the smoke has absolute access to the meat and that's a good thing.
As mentioned earlier, this can be done on bradley racks, directly on the smoker grate or you can place the open foil pan of ribs (uncovered) onto the smoker grate.
If using the pan method, you'll want to rearrange the ribs after an hour to make sure all of the ribs are getting plenty of smoke.
After 2 hours of cooking with smoke, the ribs will be looking and smelling really good but they still have a ways to go.
It's time to tenderize them with a little braising action.
If the ribs are on racks or directly on the smoker grate, it's time to toss them into a foil pan. Sprinkle a little of Jeff's original rub (Purchase formula here | Purchase bottled rub) on them for the first layer of flavor. During the braising process, there will be a lot of steam inside the pan and the rub won't necessarily stick to the ribs but it will mix with the juices and do a great job of adding flavor to the ribs.
For clarity, I had a rack of baby backs and a rack of spare ribs in the pan. I used about ¼ cup of Jeff's original rub (Purchase formula here | Purchase bottled rub) to just give the ribs a good dusting of flavor.
Cover the foil pan of rubbed ribs with foil. Make sure it's tight around the edges to keep the steam inside.
Put them back into the smoker at 225-240°F.
Leave them this way for about 1.5 hours depending on how tender you want them. It's ok to check them at the end of 1 hour and see how tender they are getting.
As ribs get more tender, the meat tends to pull back exposing the ends of the bones. You want to see the bones sticking out about ¼ in most cases.
When this step is finished, simply remove the foil cover from the top of the pan.
Now we arrive at the fun part of the process!
I hope you have some of my barbecue sauce (Purchase formula here | Purchase bottled sauce) ready. If you have the recipe and make it yourself, I recommend having it in a squeeze bottle with the end cut large enough so it's easy to squeeze it out.
Apply about a cup of Jeff's barbecue sauce all over the ribs. This not only adds flavor, it creates an excellent medium for helping the delicious rub to stick to the ribs.
Toss the ribs around in the pan to make sure they are well coated with the sauce.
Toss the ribs around again to get the rub all over as evenly as possible.
With the top left uncovered, continue to cook the ribs for an additional 2 hours or until they are at the consistency that you want.
I tested one at the 1.5 hour mark and decided they needed another 30 minutes. I recommend you test them in the same manner.
When they are done cooking, you can cover them with foil, and hold them on low heat for an hour or serve them right away.
Since they are already sliced up, Dump them into a serving container or let folks grab them right out of the pan.. your choice.
So what's so great about this new way of cooking ribs in the smoker?
First and foremost, you get more surface area to apply rub and sauce. I get lots of emails about how to make ribs more flavorful and some even ask if it helps to brine them.
I have not had a ton of luck brining ribs and I have played around with it.
By cutting the ribs into single pieces with a bone that runs through the center, you end up with more meat surface area for the smoke to get into and ultimately you can apply sauce and rub to the cut sides instead of just the top and bottom of the rib.
I would NOT go so far as to say it's any better than ribs that I cook without slicing them first but sometimes it's nice to do things in a new way just to change things up. Give it a try and I'd love to hear what you think about it in the comment section below.
Can you go ahead and apply mustard and rub like usual once you've sliced them up?
Sure! Slice them babies up, and apply yellow mustard and then rub. toss them all around to get a good even coating all over and you will have some really tasty ribs. Heck, you could even do this the night before if you wanted to.
You still might want to apply a little more rub after the braising process since the steaming tends to cause some of the rub to melt away. There's still a lot of flavor left there but I would definitely add another sprinkling and maybe even some barbecue sauce if you want to.
You should not be using aluminum as it's been linked to Alzheimers?
This is a controversial subject and while I have not decided, as of yet, to eliminate the use of aluminum for cooking in my home, if you have, then, you can certainly use a pan made from a food safe and heat safe material.
It seems that pre-slicing the ribs might make them dry out more?
It may seem that way but, in my own tests, they were just as tender and moist as any rib I've ever made as a whole slab.
Pre-slicing Ribs Before Smoking Them
- 1-2 racks of baby backs , spare ribs or a mix of the two
- Foil pans
- Jeff’s barbecue sauce recipe
- Jeff’s original rub recipe
Step 1: Rinse and Pat Dry
- Remove ribs from package and rinse well under cold water
- Pat dry with paper towels and lay on cutting board
Step 2: Remove Membrane
- If the ribs have a membrane (thick plastic-like skin on bone side), it’s a good idea to remove it if you can.
Step 3: Slice
- Baby backs: Use a very sharp knife and slice right between the bones.
- Spare ribs: For best results, trim these up St. Louis style. This just means you remove the brisket bone that runs along the leading edge and square them up a little by removing the extra pieces of meat on the ends. Then slice them up.
Step 5: Get the Smoker Going
- These will do well on any smoker or even a grill as long as you can maintain temperatures between 225-240°F using indirect heat.
- Make sure you have enough smoking wood for about 3-4 hours of smoke.
- If your smoker has a water pan, I recommend using it.
- Once the smoker is set up and holding the proper temperature, you can proceed with cooking the ribs.
Step 6: Smoke for 2 hours
- Smoke them for about 2 hours at 225-240°F.
Step 7: Add Rub and Braise in Foil
- Toss them into a foil pan. Sprinkle 1/4 cup of my original rub on them for the first layer of flavor.
- Cover the foil pan of rubbed ribs with foil. Make sure it’s tight around the edges to keep the steam inside.
- Leave them this way for 1 to 1.5 hours depending on how tender you want them.
- When this step is finished, simply remove the foil cover from the top of the pan.
Step 8: Add the Main Layer of Rub and Sauce
- Apply about 1 cup of my barbecue sauce all over the ribs.
- Toss the ribs around in the pan to make sure they are well coated with the sauce.
- Now sprinkle about 1/2 cup of rub all over the tops of the ribs then shake the pan lightly to coat.
Step 9: Finish Smoke Cooking
- With the top left uncovered, continue to cook the ribs for an additional 1.5 to 2 hours or until they are at the consistency that you want.
Step 10: Serve Up
- When they are done cooking, you can cover them with foil, and hold them on low heat for an hour or serve them right away.
- Dump into a serving container or let folks grab them right out of the pan.. your choice.
***Note: you get the Texas style rub recipe free with your order!
If I could give these recipes away, I would do that. I really want you to have them! But, then, this is how I support the newsletter, the website and all of the other stuff that we do here to promote the art of smoking meat.
Read these recent testimonies:
I recently purchased both recipes. The files did not come thru right but Jeff was prompt to get it fixed. I tried them both last weekend and they were a huge hit. I followed his burnt ends recipe to the letter and my neighbors thought I was some master chef! Thanks Jeff! -Susan T.
Thank you for the great advice. Followed your rib recipe and everyone loved them. Used your rub and sauce. On point! -Charles W.
Love the sauce and rub recipes. So far I have used them on beef ribs, pork ribs, and different chicken parts. Can't wait to do a beef brisket. Texas rub is great as well! -Peter S.
Love the original rib rub and sauce! We have an annual rib fest competition at the lake every 4th of July. I will say we have won a great percent of the time over the past 15 years so we are not novices by any means. However, we didn't win last year and had to step up our game! We used Jeff's rub and sauce (sauce on the side) and it was a landslide win for us this year! Thanks Jeff for the great recipes. I'm looking forward to trying the Texas style rub in the near future! -Michelle M.
I tried the rub on a beef brisket and some beef ribs the other day and our entire family enjoyed it tremendously. I also made a batch of the barbeque sauce that we used on the brisket as well as some chicken. We all agreed it was the best sauce we have had in a while. -Darwyn B.
You see the raving testimonies and you wonder, “Can the recipes really be that good?”
No worries! Make up a batch and if it's not as good as you've heard.. simply ask for a refund. Now that's a bargain and you know it. Let's review:
- You decide you don't like the recipes.. you don't pay!
- The recipes are absolutely amazing!
- Once you order, there'll be no more recipe ads in the email version of the newsletter
Well.. what are you waiting for.. click on the big orange button below to order the recipes now.
With more than 900 reviews on Amazon.com and a rating of 4.7 out of 5 stars, it comes highly recommended.
It is a Bestseller in Barbecueing & Grilling books on Amazon.
If you enjoy the newsletter and would like to do something helpful, then..
The next time you decide to order something at Amazon.com, use THIS LINK to get there and we'll get a small commission off of what you purchase.
Thank you in advance for using our special link: http://www.smoking-meat.com/amazon